% Update: {3. 3. 1992              Peter Kutschera}
% ----------------------------------------------------------------------------
%
%                                  Hans Wolfgang Loidl, RISC-Linz,  31.10.1991 
%
% This is a template file of the `form' for a group-description!
%
% Changes:    <By whom>, <When>, <What changes> 
%
%  H.W.Loidl, 7.11.1991, relative path added in input
%
%  Subpart of the ACPC-Manual.
%  Each group should create a file like this and include it via \input{..}
%  in the acpc-manual.tex file.
%  This file is a description of the facilities of a group.
%  The overall structure of this file is:
%     Forall computers :
%       * Hardware form
%       * Forall software products : Software form
%  It is recommended to make separate files for the description of the
%  hardware and of each software product. Such a file is obtained by filling
%  in the hardware or software form.
%  NOTE: This is no independent LaTeX file. It has to be included into the
%        ACPC Manual or in a `frame' LaTeX file (see `grp-frame.tex') where
%        formating information etc is given.
% REMARK (due to 1st change):
%  In contrast to the sw-form and the hw-form this file should NOT be
%  located in the subdir of the group but in the same dir as the 
%  ACPC  Manual!    Otherwise  the pathes of the files that are `\input'ed 
%  in the group description file are not correct!
%
% ----------------------------------------------------------------------------

\section{Group Description of the Institute for Software Technology and
Parallel Systems, University of Vienna (PPS)}

\input{PPS/group-form.tex}

% For all computers of a group:

\input{PPS/IPSC-i860-hw.tex}
\input{PPS/IPSC-i860-sw.tex}

\input{PPS/transputer-hw.tex}
\input{PPS/transputer-sw-icc.tex}
\input{PPS/transputer-sw-oc.tex}
\input{PPS/transputer-sw-config.tex}

\input{PPS/maspar-hw.tex}
\input{PPS/maspar-sw.tex}


